Specifications

7193 Service Guide Chapter 2: Installing the Printer

August 1998 19

Mounting the Power Supply on a Wall

The power supply comes with a wall-mount kit to mount the power supply on the wall or

under a table. See “Appendix B: Ordering Paper and Supplies” for information on ordering

the power supply and wall-mount kit.

The kit contains a holder and screws with plastic anchors. Be sure there are no hidden

wires or other obstructions in the wall where you mount the power supply.

You will need a 1/4 inch drill bit and either a Phillips or standard screwdriver (screws are

combination Phillips and pan-slotted).

Using the bracket as a template, mark and drill a hole for each plastic anchor 1.25

inches deep.

Insert the anchors into the holes so they are flush with the wall surface and screw the

holder against the wall, tightening the screws so that the plastic anchors expand and

hold firmly in the wall.

Do not overtighten the screws.

Note: You must unplug the power cord in order to place the power supply in the holder.

First, take the printer off-line by pressing the On Line button on the operator panel (the On

Line light goes off indicating the printer is off-line), unplug the power cord from the outlet,

then unplug the power cord from the power supply.

Place the power supply in the holder.

Plug the power cord into the power supply.

Plug the power cord into an outlet.

Note: You can use the tie-wrap to wrap the power supply cable to keep it out of the way.