Specifications

7193 Owner’s Guide Chapter 6: Commands
August 1998 61
Note: If the Set Horizontal and Vertical Minimum Motion Units command (1D 50) is used
to change the horizontal and vertical minimum motion unit, the parameters of this
command (Set Absolute Starting Position) will be interpreted accordingly. For more
information, see the description of the Set Horizontal and Vertical Minimum Motion Units
command earlier in this chapter.
Set Bit Image Mode
Sets the print resolution and enters one line of graphics data into the print buffer. Any
print command is required to print the data, after which the printer returns to normal
processing mode. See the illustrations for graphic representations of the bit image.
Hexadecimal Decimal ASCII
1B 2A m n1 n2 d1 ... dn 27 42 m n1 n2 d1 ... dnESC * m n1 n2 d1 ... dn
Value
of m
Mode
No. of Dots
(Vertical)
No. of Dots
(Horizontal)
Number of
Dots/LIne
0 8 Dot Single Density 8 (51 DPI) 0-224 (76 DPI) 8 x 224
1 8 Dot Double Density 8 (51 DPI) 0-448 (152 DPI) 8 x 448
32 24 Dot Single Density 24 (152 DPI) 0-224 (76 DPI) 24 x 224
33 24 Dot Double Density 24 (152 DPI) 0-448 (152 DPI) 24 x 448
Value of n (8-Dot Single
Density Mode)
Value of n (24-Dot Single
Density Mode)
Value of d
n1 + (256 x n2) 3 x [n1 + (256 x n2)]
Number of Bytes of Data
(Printed Down, Then Across)
Top of Bit Image
Receipt
8-Dot Single-Densit
y
Mode
d4 d3 d2 d1 dn dn
MSB
LSB