Specifications

Commands 7193 Owner’s Guide
May 199668
Set Line Spacing to 1/6 Inch
Sets the line spacing to 1/6 of an inch (4.25 mm). It is not affected by the Print
(17) command.
Hex Decimal ASCII Default
1B 32 27 50 ESC 2 0.13 Inch (3.33 mm)
Set Line Spacing to n Minimum Units
Sets the line spacing to n/360 of an inch. The minimum line spacing is 8.5 lines
per inch. The line spacing equals the character height when n is too small.
Hex Decimal ASCII Value of n Default
1B 33 n 27 51 n ESC 3 n 0-255 0.13 Inch (3.33 mm)
Select Printer
This command is not implemented and is ignored if received.
Hex Decimal ASCII Value of n Default
1B 3D n 27 61 n ESC = n 0 (bit 0), printer not selected
1 (bit 0), printer selected
1
Initialize Printer
Clears the print line buffer and resets the printer to the following default
selections (startup configuration):
• Single-Wide, Single-High, Non-Rotated, and Left-Aligned characters are set
• Extra Dot Rows are set to two
• User-defined characters or logo graphics (from RAM) are cleared
• Character Set is set to Code Page 437 (default)
• Character Pitch is reset to 15.2 CPI and column width to 44 (default)
• Returns paper exhaust to the paper status line if an alternate status has been
requested (Parallel interface only)
Hex Decimal ASCII
1B 40 27 64 ESC @