Specifications

Programmer’s Guide Model 181 Series 180 Software Commands
TransAct Technologies
09/26/2000 Page 5 - 43
m
Connector pin
0, 48 Drawer 1 kick-out connector pin 5.
1, 49 Drawer 1 kick-out connector pin 2 (J9 2-3)
** See Appendix X for Cash drawer connector information.
*
B
m
Connector pin
0 Drawer 1 kick-out connector pin 2.
1 Drawer 1 kick-out connector pin 5.
ESC =
n
[EA]
[Name] Set peripheral device
[Format] ASCII ESC =
n
Hex 1B 3D
n
Decimal 27 61
n
[Range] 1 
n
 255
[Description] Selects device to which host computer sends data, using
n
as follows:
Bit Off/On Hex Decimal Function
0 Off 00 0 Printer disabled.
On 01 1 Printer enabled.
1-7 - - - Undefined.
 When the printer is disabled, it ignores all received data with the exception of the ESC
=, DLE ENQ 1 and DLE ENQ 2 commands.
 If ASB is enabled when the printer is disabled by the ESC = command, the printer
transmits a 4-byte status message whenever the status changes.
DLE ENQ
n
[E*]
[Name] Real-time request to printer
[Format] ASCII DLE ENQ
n
Hex 10 05
n
Decimal 16 5
n
[Range] 1 
n
 2
[Usage] *Epson TM-T8x emulation mode only.
[Description] Responds to a request from the host computer.
n
specifies the request as
follows:
n
Request
1 Recover from an error and restart printing from the line where the error occurred
2 Recover from an error after clearing the receive and print buffers
 When an auto-cutter error occurs, the printer can attempt to recover from the error by
using this command without turning the printer off.