Specifications

Programmer’s Guide Model 181 Series 180 Software Commands
TransAct Technologies
09/26/2000 Page 5 - 41
EM [EA]
[Name] Full knife cut
[Format] ASCII EM
Hex 19
Decimal 25
[Description] This command is implemented the same as partial knife cut, ESC i.
SUB [A]
[Name] Partial knife cut
[Format] ASCII SUB
Hex 1A
Decimal 26
[Description] Performs a partial knife cut.
Miscellaneous Commands
GS P
x y
[E]
[Name] Set horizontal and vertical motion units
[Format] ASCII GS P
xy
Hex 1D 50
xy
Decimal 29 80
xy
[Range] 0 
x
 255
0 
y
 255
[Default]
[
Epson TM-T8x
]
x
= 180,
y
= 360
[
Axiohm 7193
]
x
= 152,
y
= 152
[Description] Sets the horizontal and vertical motion units to 1/
x
inch and 1/
y
inches,
respectively. When
x
and
y
are set to 0, the default setting of each value is
used (see defaults above).
ESC @ [EB]
[Name] Initialize printer
[Format] ASCII ESC @
Hex 1B 40
Decimal 27 64
[Description] Clears the data in the print buffer and resets the printer to the mode that
was in effect when the power was turned on.
DLE [A*]
[Name] Clear printer
[Format] ASCII DLE
Hex 10
Decimal 16
[Usage] *Axiohm 7193 emulation mode only.