Specifications

Programmer’s Guide Model 181 Series 180 General Information
TransAct Technologies
09/26/2000 Page 3 -5
Warning:
Use a drawer that matches the printer specification. Using an improper drawer
may damage the drawer as well as the printer.
Caution:
Do not connect a telephone line to the drawer kick-out connector; otherwise the
printer and the telephone line may be damaged.
CONNECTING THE POWER SUPPLY
Use the optional Ithaca Phi-Hong PSA-53 or equivalent power supply for your
printer. The following illustration shows the power cable connector and pin
assignments. The power cable connector is a 3 pin mini DIN plug and is located in the
small cavity under the printer.
Earth Ground
24 Volt supply
-
24 Volt supply +
Warning:
Make sure that you use the Ithaca Phi Hong PSA-53 power supply or equivalent.
Using an incorrect power supply may cause fire or electrical shock
.
Caution:
If the power supply’s rated voltage and your outlet’s voltage do not match,
contact your dealer for assistance. Do not plug in the power cord. Otherwise, you may
damage the power supply or the printer.
1. Make sure that the power supply’s power cord is unplugged from the electrical
outlet.
2. Check the label on the power supply to make sure that the voltage required by
the power supply matches that of your electrical outlet.
3. Plug in the power supply’s cable as shown below.
Note:
To remove the DC cable connector grasp the connector at the arrow and
pull it straight out.