Specifications

General Information Model 181 Series 180 Programmer’s Guide
TransAct Technologies
Page 3 -4 09/26/2000
CONNECTING THE CASH DRAWER CABLES
The cash drawer option, (with a ”Y” connector) allows up to two cash drawers to
be connected to the printer in a system with a PC that has no connectors for the
cash drawer cables.
The cash drawers are operated by software commands from the host system
through the printer. For additional information on the printer commands used by
the host system to activate the cash drawer, see “Control Code Library” later in
this manual.
1. Plug the cash drawer cable into the connector on the printer.
The connector is a standard phone connector.
Note: The following illustration shows the pin outs for the cash drawer
connectors, as viewed from the rear of the unit.
Cash Drawer Power Connector
123456
EPSON ITHACA STAR
J7
PIN # 1-2, 3-4, 5-6, 7-8,
9-10
*
J7
PIN # 2-3, 4-5, 6-7, 8-9,
10-11
J7
PIN # 5-6, 7-8, 9-10, 11-12,
13-14
1 Frame Ground Dwr 2 Drive – (GND switched) Frame Ground
2 Dwr 1 Drive – (GND switched) Status Switch + Dwr 1 Drive – (GND switched)
3 Status Switch + Ground Dwr Drive + (24 volt)
4 Dwr Drive + (24 volt) Dwr Drive + (24 volt) Dwr Drive + (24 volt)
5 Dwr 2 Drive – (GND switched) Dwr 1 Drive – (GND switched) Dwr 2 Drive – (GND switched)
6 Ground Frame Ground Status Switch +
*
Default