Instructions

Operation Instructions | SES 5532-19 | Programmable Unicable II Multiswitch
10 2020-06-30 | Technical improvements, changes in design, printing- and other errors expected.
3.4. Reception of two or four satellites
For this, the SES 5532-19 must be correspondingly configured by means of the programmer SZU 55-00.
The figure shows the installation for the reception of two satellites (left) or four satellites (right) via two
wideband LNBs (e.g. SCO 2-00).
3.4.1. Connection of the wideband LNBs
At the SES 5532-19 the second line applies to 2 × wideband LNB.
Connect the outputs of the first wideband LNB with the left inputs V and H of the SES.
Connect the outputs of the second wideband LNB with the right inputs V and H of the SES.
Make sure to connect the correct outputs of the wideband LNB with the correct inputs of the SES.
The multiswitch is equipped with a terrestrial input. Connect the terrestrial antenna to this input, if required.
Information: The prerequisite for the installation for four satellites is that the outputs of both multiswitches
are connected to SZU 55-02.