Instructions

Operation Instructions | SES 5532-19 | Programmable Unicable II Multiswitch
6 2020-06-30 | Technical improvements, changes in design, printing- and other errors expected.
In this mode, the transponder table (NIT = Network Information Table) for the receivers is not available.
Therefore, the so-called blind scan must be carried out on the receiver.
Unicable I pre-programming
The user bands of the AXING Unicable I multiswitch are used by the SES 5532-19. This allows the replacement
of the existing SES 556-x9 single cable multiswitches.
Programming
The basic configuration of the SES 5532-19 can be changed by means of the SZU 55-00 programmer ( available
as an accessory). The PC software can be downloaded at www.axing.com | Download.
Note: The software includes an online help (starts with key F1). In this help you will find a detailed description
of all programming steps. The SES 5532-19 is called ODU (Out-Door-Unit) in this online help.
Legacy output
When the device is switched on for the first time, the legacy output acts as a standard universal connection
and allows you the connection of receivers which do not support the Unicable/Unicable II (EN50494/EN50607)
protocol; however, it switches to the Unicable II mode as soon as an EN50494 or EN50607 DiSEqC signal is
received. After that, the 32 user bands are available via the two outputs. The corresponding user band is
available only via the output which was used to activate it.