Manual

Operation instructions | EOC 1-32 and EOC 2-32 | Ethernet over Coax Peer to Peer
Page 18 of 26 AXING-BA_EOC-1-2-32.pdf | Technical improvements, changes in design, printing and other errors reserved. | 2022-08-16
5.6. 5-GHz-Band VAP (Virtual Access Point)
In the 5G VAP window, you configure the parameters of the 5 GHz band.
Service
• Enable switches on the 5 GHz band.
• Disable switches off the 5 GHz band.
SSID
 Enter the name of your WIFI network here.
The name can be up to 15 characters long.
Security Mode
Define the security of your WIFI network here.
• Open: No security
• WPA-PSK/WPA2-PSK Mixed: Wi-Fi-Protected-Acces with Pre-Shared-Key or
Wi-Fi-Protected-Acces with Pre-Shared-Key are used
depending on the terminal device.
• WPA3 End devices must support Wi-Fi Protected Access 3
Pre-Shared Key
• Specify a WIFI security key for the WIFI connection here.
• Note: The pre-shared key must be at least 8 and at most 16 characters long and must not contain any
special characters, only numbers and letters.
Cypher
TKIP (Temporal Key Integrity Protocol) and CCMP (Counter Mode with Cipher Block Chaining Message
Authentication Code Protocol and AES (Advanced Encryption Standard) are encryption methods.
• Auto detects (depending on what the terminal device supports) either CCMP(AES) or TKIP.
• CCMP(AES), the Advanced Encryption Standard is used.
• TKIP, the Temporal Key Integrity Protocol is used.
 Click Update to apply the entered values.
Important: This does not yet activate the changes in the EOC. Only when you activate them on the Active
Changes page will the changes actually be applied to the device (see 5.8 on page 21).