Manual

Operation instructions | EOC 1-32 and EOC 2-32 | Ethernet over Coax Peer to Peer
Page 4 of 26 AXING-BA_EOC-1-2-32.pdf | Technical improvements, changes in design, printing and other errors reserved. | 2022-08-16
1. Product description
1.1. Scope of delivery
• EOC 1-32 or EOC 2-32
• CAT5 ethernet cable
• 12 VDC power adapter for power supply
• Quick start guide
1.2. Principle of operation
The EOC 1-31 and EOC 2-31 respectively, use the G.hn standard to build an Ethernet-over-coax network via the
coaxial cables of the house installation. Television and radio will continue to broadcast over it.
• Up to 16 EOC 1-32 or EOC 2-32 (also mixed) can establish connections with each other.
• The EOC 1-32 or EOC 2-32 cannot be connected to AXING EOC devices other than the types mentioned or
to third-party products.
• The EoC devices use the frequency range of 5...204 MHz. All components in the distribution structure must
passively transmit this frequency range in both directions.
• The attenuation in the coaxial network must not exceed 77 dB between the EoC units. For optimal data
rates, the attenuation should not be higher than 50 dB.
• If the EoC signals are fed into the terrestrial range of a multi-switch, then this input must be passive.
Furthermore, in order to use the full data rate of the EoC system, the terrestrial input must support the
frequency range from 5 to 204 MHz. In a multiswitch cascade system, the conditions apply to the entire
terrestrial branch.
• The device types EOC 1-32 and EOC 2-32 may only be used in a CATV network if the forward path
frequency range of the CATV network starts from 258 MHz.