User manual

63
8.1.2 Add SBM Rules
1. Click on [Add] tab. You will see the following screen.
2. Configure [Add SBM] Settings following the instructions below.
Sequence Number
This defines the sequence of the SBM rules. If a packet fits the
conditions set by the SBM rules, the packet will then be sorted
according to the first SBM rule from the top of the list.
Rule Name
Name of the SBM rule.
Rule Enable
Enable/Disable this SBM rule
Internal IP
Set up the internal IP for this SBM rule.
Protocol
Set up the protocol (TCP or UDP) for the ACL to be enabled.
External Interface
Please select which External Interface (WAN1 or WAN2) you want a
packet to go through, IF the packet fits the condition of this SBM rule.
Service Port Range
Set up the Service Port Range (e.g., HTTP is TCP/80) for the SBM to be
enabled.
Bandwidth Allocation
By Ratio or By Bandwidth
Ratio
The ratio of the whole bandwidth according to the External Interface.
Download
Enter the reserved download bandwidth.
Upload
Enter the reserved upload bandwidth.
Utilize Bandwidth
More than
Guaranteed
Check this box if you wish to allow the traffic confirming this SBM rule to
be able to utilize the whole bandwidth when the bandwidth is idle.