User manual

45
6.3 WDS SETUP
WDS (Wireless Distributed System) enables the wireless bridging amongst several wireless devices. The bridged
devices are identified by the WDS MAC addresses.
1. Click on [Wireless] – [WDS] tab. You will see the following screen.
2. Configure WDS settings following the instructions below.
WDS
Select Enable to enable WDS function.
Select Disable to disable WDS function.
MAC Address [1~4]
Enter the MAC addresses of the other bridged wireless devices.
Maximum of 4 devices are allowed to be bridged together.
*Please make sure of the following settings in order to allow WDS to work effectively:
(1) WDS bridged devices must use the same radio channel.
(2) WDS bridged devices must use the same encryption mode and encryption keys.
Please Note: If one of the above fails, WDS devices cannot communication with each other.