User manual

30
5.4.2 Add Routing Rule
1. Click on [Add] tab. You will see the following screen.
2. Configure the Routing rule following the instructions below.
Sequence Number
This defines the sequence of the Routing rules. If a packet fits the
conditions set by the Routing rules, the packet will then be sorted
according to the first Routing rule from the top of the list.
Rule Name
Name of the Routing rule.
Enable
Enable/Disable this Routing rule
Internal IP Range
Set up the internal IP range for this ACL rule.
External IP Range
Set up the external IP range for this ACL rule.
Protocol
Set up the protocol (TCP or UDP) for the ACL to be enabled.
Service Port Range
Set up the Service Port Range (e.g., HTTP is TCP/80) for the ACL to be
enabled.
External Interface
Please select which External Interface (WAN1 or LAN1) you want for a
packet to go through, if the packet fits the condition of this ACL rule.
Routing Gateway
Please select which Gateway(Default or Static) you want to route to.
Gateway IP Address
Please enter the Gateway IP Address if you choose Static Gateway in
the Routing Gateway menu.