AXI90060 Axial SCX10 II 2017 Jeep Wrangler Unlimited CRC RTR Manual

AE-5L Forward/Reverse EAS w/ Drag Brake
4 LED White & Red Light String
Mount the ESC in an area that is well ventilated and isolated from vibration and shock.
Connect the ESC motor wires to the motor red-red & black-black.
Plug the receiver with into the throttle channel on the receiver. The black negative wire should be
towards the outside of the receiver.
Before plugging the battery into the ESC, make sure your transmitter is on and the throttle trim is set at
zero.
Connect the battery to the ESC, this will turn on the ESC.
Test forward and reverse control using the transmitter.
To calibrate the ESC, make sure the transmitter is on and the throttle control is at neutral.
Connect the battery to the ESC and wait 3 seconds to let the ESC initiate a self-test and automatic
throttle calibration.When the ESC is ready to run a long beep sound will be emitted from the motor.
Always disconnect the battery when the vehicle is not in use.
Connecting the 2 LED wires to the ESC. The wires should color match.
Rear
Included with vehicle.
AX31480
AE-5L ESC w/ LED Light Ports
Receiver Servo
White LED's
Red LED's
Red/Black Only
Rear
Front
White/Black Only
2 LED White Light String
(included with optional AX31481 LED Light Set)
11