Yeti Jr. Can-Am Maverick X3 RTR Manual

CHANGING THE THROTTLE LIMIT

Beginner Mode

Throttle Limiting Switch: 50%

Best for learning the basic func tions of left ,right,stop,brake and reverse

For use in smaller areas

Longest battery life

Best Overall Performance (Default)

Throttle Limiting Switch: 75%

Great top speed and acceleration

Easier to accelerate in desired direction,especially on loose surfaces

when compared to Maximum Speed setup

Run time is greatly in creased over Maximum Speed setup with

minimal impact to top speed

Maximum Speed

Throttle Limiting Switch: 100%

More capable of popping and holding wheelies

Higher top speeds and maximum acceleration

Throttle Limit Switch

Your new Horizon Hobby SRX210 Receiver has a special wate

-resistant coating on the electronics to ensure reliable per

formance in higher than average moisture conditions.

This conformal coating can offer mild protection from light drops of water.

DO NOT submerge this product under water for any period of time . If it is submerged, it may result in damage or loss of

function.

DO NOT pour water onto or allow excess water to come in direct contact with the product..

DO NOT operate this product in heavy rain or snow.

DO NOT expose this product to salt water (ocean water or water on salt-covered roads), contaminated or polluted water.r.

In case of excess exposure to water or debris, immediately wipe down the SRX200 with a soft cloth and allow it to fully dry

before next use.

NOTICE: Never use a pressure washer to clean your vehicle.

NOTICE: Make sure the other components in your vehicle are waterproof or water-resistant before driving in wet conditions.

Water -Resistant Component

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identiﬁer) code of a single speciﬁc transmitter.

1. Power OFF the ESC/Receiver and transmitter.

2. Connect a fully charged battery to the

ESC/Receiver.

3. Power on the ESC/Receiver. It will beep once and the LED will ﬂash rapidly, indicating it is in bind mode.

4. To put the STX2 transmitter into bind mode,hold the steering wheel fully to the right

wheel after 2 seconds.

while powering on the transmitter. Release the steering

5. The LED on the ESC/Receiver will go solid and the ESC/Receiver will make a rising tone, indicating the bind is successful.

You must rebind when binding the receiver to a different transmitter.

NOTICE: Do not attempt to bind the transmitter and receiver if there are other compatible transmitters in bind mode within 400 feet.

Doing so may result in unexpected binding.

BINDING