Yeti Jr. Can-Am Maverick X3 RTR Manual

18
INSTALLING TRANSMITTER BATTERIES
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries may
cause the batteries to burst, resulting in injury to persons and/or damage
to property.
This transmitter requires 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cove r.
CAUTION: Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to national regulations.
TRANSMITTER CONTROLS
2.4GHZ DIGITAL
RADIO SYSTEM
1
2
11
3
4
8
7
9
6
10
5
12
1. Steering Wheel
Throttle Trigger
Controls direction (left/right) of the model
2. Controls speed and direection(forward/brake/reverse）
of the model
3. ON/OFF Switch Turns the power for the transmitter
4. Throttle Limiting Switch Adjusts the throttle limit from 50%, 75%, and 100%
5. TH Rate
Adjusts the end point of the throttle
6. TH Trim
Adjusts the throttle neutral point
7. TH REV
Reverses the function of the speed control when pulled back
or pushed forward
8. ST REV Reverses the funcion of the steering When the wheel is turned left or right
9. ST Trim Adjusts the steering center point
10. ST Rate Adjusts the end point of the steering
11. Antenna
ransmits the signal to the model
12. Indicator Lights
Solid red lights—indicates radio connectivity and adequate battery power
Flashing red lights—indicates the battery voltage is critically
low. Replace batteries