Yeti Jr. Can-Am Maverick X3 RTR Manual

14
r.
3
Turn on the transmitte
Note:
Power to the vehicle is controlled by
connecting / disconnecting the battery.
4
Connect the battery to the ESC.
5
Install the body and body clips.
2
Install the battery.
1
Remove the body clips and body.
DYNC1061 USB NiMH Charger and DYNB0112EC Battery Instructions
Before using your factory assembled RTR, review the entire instruction manual to become familiar with the vehicle.
This is a quick start guide for care and usage of the charger and battery that comes with the vehicle.
DYNC1061 - Dynamite USB Charger
NiMH 6C EC3
™
Connector
DYNB0112EC - Dynamite NiMH 7.2V
1300mAh 2/3A Flat Mini EC3
™
Connector
CAUTION: The DYNC1061 charger is for
use with 6-Cell 7.2v NiMH batteries ONLY and
should not be used with any other batteries.
CAUTION: Never leave the battery unattended
while charging. Always disconnect the battery
and unplug the charger when finished charging.
CAUTION HOT!!!
NiMH batteries may become hot while charging.
Allow to cool before handling the battery.
When using the DYNC1061 charger, the DYNB0112EC battery should fully charge in 2-3 hours.
• Remove the battery from the vehicle
before charging.
• Place the battery on a fire resistant surface away
from combustible materials.
•
Keep the battery and charger away from water
and other fluids. Never charge a wet battery.
1. Connect the USB connector to a PC USB port
or to a USB AC wall adapter.
2. Connect the battery to the EC3
™
connector on the charger.
3. The charger will automatically begin
the charger process.
Red LED: Charging
Green LED: Finish Charging