1/10 SCX10 II Deadbolt 4WD Crawler RTR Manual

ManualsBrandsAxial ManualsCars & Trucks1/10 SCX10 II Deadbolt 4WD Brushed RTR, Tan

INSTALL THE TRANSMITTER BATTERIES

TRANSMITTER FUNCTIONS

BINDING

This transmitter requires 4 AA batteries.

1. Remove the battery cover from the transmitter.

2. Install the batteries as shown.

3. Install the battery cover.

CAUTION: NEVER remove the transmitter batteries while the

model is powered on. Loss of model control, damage, or injury

may occur.

CAUTION: If using rechargeable batteries, charge only

rechargeable batteries. Charging non-rechargeable batteries

may cause the batteries to burst, resulting in injury to persons and/or

damage to property.

CAUTION: Risk of explosion if battery is replaced by an incorrect

type. Dispose of used batteries according to national regulations.

Follow the manufacturer’s directions for your charger to properly

charge the vehicle battery.

CAUTION: Only use chargers designed to charge the chosen

battery type. Using an incorrect charger or incorrect charger

settings could cause the battery to catch ﬁre or explode.

CHARGE THE VEHICLE BATTERY

1. Steering Wheel Controls direction (left/right) of the model

2. Throttle Trigger Controls speed and direction (forward/brake/

reverse) of the model

3. Power Button Turns the power on/off

4. Steering (ST-R) Servo Reversing Reverses the steering channel

5. Throttle Limit Limits throttle output to 50/75/100%

Select 50% or 75% for less experienced drivers or when you are

driving the vehicle in a small area

6. Indicator Lights

Solid red light—Indicates radio connectivity and adequate

battery power

Flashing red light—Indicates the battery voltage is critically

low. Replace the batteries

7. Steering Rate Adjusts the steering end points

8. Steering Trim Adjusts the steering center point

Binding is the process of programming the receiver to recognize the GUID (Globally

Unique Identiﬁer) code of a single speciﬁc transmitter. The transmitter and receiver

are bound at the factory. If you need to rebind, follow the instructions below:

1. Insert the bind plug into the bind port of the receiver.

2. Connect a fully charged battery to the ESC.

3. Power on the ESC

4. Power ON the transmitter. The receiver’s red LED will turn solid when the

bind is successful.

5. Power OFF the ESC to save the settings.

6. Power OFF the transmitter.

7. Remove the bind plug and store for later use. The bind plug should not be

installed while driving.

You must rebind when binding the receiver to a different transmitter.

NOTICE: Do not attempt to bind the transmitter and receiver if there are other

compatible transmitters in bind mode within 400 feet. Doing so may result in

unexpected binding.