User Manual

INSTALL THE TRANSMITTER BATTERIES

TRANSMITTER FUNCTIONS

This transmitter requires 4 AA batteries.

1. Remove the battery cover from the transmitter.

2. Install the batteries as shown.

3. Install the battery cover.

CAUTION: NEVER remove the transmitter batteries while the model

is powered on. Loss of model control, damage, or injury may occur.

CAUTION: If using rechargeable batteries, charge only

rechargeable batteries. Charging non-rechargeable batteries may

cause the batteries to burst, resulting in injury to persons and/or damage

to property.

CAUTION: Risk of explosion if battery is replaced by an incorrect

type. Dispose of used batteries according to national regulations.

A. Servo Reversing

To reverse the Throttle (TH) or Steering (ST) channel, switch the position

of the correlating switch—“N” is for normal, “R” is for reverse.

B. Throttle Trim

Adjusts the throttle neutral point

C. Steering Trim

Adjusts the steering center point. Normally, the steering trim is adjusted

until the vehicle tracks straight.

D. Brake Rate

Adjust Brake rate.(For use with AVC Rx’s)

E. Steering Rate

Adjusts the end point of the steering

F. Indicator Lights

• Solid red lights: Indicates radio connectivity and adequate battery power

• Flashing red lights: Indicates the battery voltage is critically low.

Replace batteries

G. Throttle Limit

Limits throttle output to 50/75/100%

Select 50% or 75% for less experienced drivers or when you are driving

the vehicle in a small area.

H. Antenna

I. Power Button

J. Throttle/Brake

K. Steering Wheel

Follow the manufacturer’s directions for your charger to properly charge

the vehicle battery.

CAUTION: Only use chargers designed to charge the chosen

battery type. Using an incorrect charger or incorrect charger

settings could result in a ﬁre causing personal injury or damage to property.

CHARGE THE VEHICLE BATTERY