User's Manual

- 9 -
© QuestLabs Limited
1.4. Battery installation
1. Disconnect the power supply.
2. Open battery cover on the bottom side of TG130.
3. Connect the DC power cable to TG130.
4. Close the battery cover.
5. Connect the power supply to TG130.
1.5. Installation of the antenna and location of the equipment for voice service
Before you select a localization to place TG130(F), you should read the section for their Security in the first
part of this manual. You can place it in a plane area just as the floor, the walls or the desk or table.
1. it connects the antenna at the TG130(F) (previously it should couple the antenna in their support, make
sure of making the one it couples in a complete way, verify that the antenna mo is slack) and locate her it
more far possible of the terminal. If the antenna is located near the TG130(F) noise she/he will take place
during the communication, avoid it!
* Notices: make sure of pressing the antenna completely to their connector in the terminal.
2. Using the marked port as “Phone “connects the TG130(F) to the central PBX, or to the system of tariff of
the booth or a similar telephone. If their Terminal is model TG130F and you will use similar fax, connect the
fax machine to the port “Fax ".
3. Connect the adapter to the Terminal. Use the connector "DC Input."
4. Connect the adapter DC in an appropriate energy plug.
5. Turn on the terminal. Use the switch “On/Off ".
6. Checks the power of the signal GSM, verify the state of the led “Signal “(check the section 2.1). To improve
the signal reception, move the antenna and verify the state of the led “Signal ".
Avoids leaving the antenna in a location in which the led illuminates red or be shut down
7. The terminal is ready to be used.