User's Manual

- 22 -

FEATURE MODE STRING DESCRIPTION

Bypass Mode

Voice #* 300 * 0 #

Outgoing Call is whether Voice or

Fax.

Fax #* 300 * 1 #

Fax Once #* 300 * 2 #

Fax Port Selection

Serial port(Digital) #* 301 * 0 #

Incoming fax call is where to be

routed.

RJ-11(Analog) #* 301 * 1 #

Fax National Setup #* 302 * 2 # Fax machine should be connected

Note: Every fax machine has settings to communicate in specific country. If you have a problem of

transmission between TG130F and local fax machine, you can change the national configuration of TG130F

by pressing dial #*302*2#. The setting is originally configured by SIM, but after performing this national-setup

TG130F will automatically find out the correct setup.

Note: After failure of sending faxes due to network problem or not working fax line, TG130F tries to transmit

twice more to designated fax machine. If the transmission was not successful in spite of 3-tries, you will

receive error report.

TG130F also tries to transmit to local fax twice more if failed to transmit faxes successfully got from remote

fax machine beyond network.

7.2. Digital Fax

1) TG130 supports

- Max 9.6kbps

TG130 can be used with any fax-software application on PC. Before using fax capability, you should verify

TG130 was plugged in PC. After then choose the right COM-Port for TG130 on your application.

When you answer faxes, you should set up TG130 to digital-mode as below.

Serial port(Digital)

#* 301 * 0 #

RJ-11(Analog)

#* 301 * 1 #

NOTE: Every fax specification except max-speed will be taken care of by your fax-software application