User's Manual

- 14 -
© QuestLabs Limited
4) EXCEPTION STATUS
LED ACTIVITY DESCRIPTION
ALL LED Flashing(Red) then
Mode LED : GREEN
Insert SIM
ALL LED Flashing(Red) then
Signal LED : GREEN
Equipment Locked, Enter Lock Code
(See 4.8 Equipment Lock section)
ALL LED Flashing(Red) then
Signal LED : AMBER
PIN Locked, Enter PIN
(See 4.9 PIN Lock section)
ALL LED Flashing(Red) then
Signal LED : RED
PIN Blocked, Enter PUK *
(See 4.9 PIN Lock section)
ALL LED Flashing(Red) then
Mode LED : AMBER
MEP Locked *
ALL LED Flashing(Red) then
Mode LED : RED
AUTO PIN Locked **
ALL LED Flashing(Red) then
Mode LED : GREEN
Cell Locked *
* Contact your service provider to verify that service has been activated.
** If your service provider use AUTO PIN feature, you must use the SIM card provided from your service
provider. If a proper SIM card is installed and ‘AUTO PIN Locked’ state continues, contact your service
provider.
3. Basic operations
3.1. Making calls
1. Check to see that your TG130 is turned on.
2. Pick up the handset of the phone.
3. If you listen for dial tone, dial the desired telephone number. The call will be automatically made by TG130.
If you hear fast beep tone, check SIM card or signal strength.
* Note : If you can’t hear dial tone produced, check to make sure that all the parts are properly connected,
hang up the phone, and try again.
If you press ‘Flash key’, or press the switch-hook and release after dialing a number,
Call will be made immediately.
3.2. Receiving calls
1. When the phone rings, pick up the telephone handset, begin to talk.
2. To disconnect after finished, replace the handset on the phone.