User's Manual

- 11 -

1.6. Desktop installation

Before you select a location to place TG130, you must read “For your safety” section in the first part of this

manual.

You can place it on the flat surface area such as above ground, on the walls, or table.

1. Connect the antenna to TG130 and locate it as far as it can reach

* Note : finger-tighten the antenna.

2. Connect a wire telephone to TG130 using phone cord

3. Connect the barrel connector of the power supply to DC Adaptor

4. Plug the DC Adaptor into the power supply.

5. Plug the DC Adaptor into an appropriate power outlet.

6. Check signal strength moving the antenna until you find the best signal possible.

(See 2.1 LED Status Indicator section)

7. If you use Data Service or PC FAX Service, connect your data cable to the Data port located at the side

of TG130.

8. If you use G3 FAX machine, connect your line cord of G3 FAX to the RJ-11port located at the side of

TG130F.