User's Manual

- 10 -

Attention: If the SIM Card (Chip) that will be used in the terminal has the number disabled PIN (it consults

to their operator), it won't be necessary to make some additional configuration in the TG130(F); this will be

ready for their use.

In case, on the contrary, the SIM Card has the active PIN that same number PIN it will be recorded in the

terminal. To make it, connect a telephone similar to the port “Phone” and dial: #* 110 * 2 * number PIN #

With the previous procedure it will be engraving in the terminal the number PIN. It is this way when the

terminal is out and then lit, it won't be necessary to carry out this procedure again. Although the Terminal

remains out a lot of time, without current and without battery, the PIN that was recorded will always remember.

IF THE PIN OF THE SIM CARD (CHIP) IT IS ACTIVATED AND SHE/HE IS NOT CARRIED OUT THE

PREVIOUS PROCEDURE CORRECTLY, THE SIM CARD WILL BE ABLE TO BE BLOCKED AND YOU

WILL HAVE TO ENTER THE NUMBER PUK TO UNBLOCK IT (TO CONSULT SECTION 4.9).

Avoid noise or interference during the communication: the antenna should be at least separated from the equipment a

meter. Avoid proximity of the team and of their antenna to electric motors, fluorescent lamps, radios, televisions,

computer monitors, speakers and in general electric equipment. Before connecting the terminal to central PBX, verify

connecting a direct telephone and making calls of test that there are not noise or interference during the call; if there is

verify the location of the equipment and their antenna.