User's Manual

Fixed Wireless Phone
7 User Manual
3 Basic Operations
3.1 Power On/Off
3.1.1 Power On
Hook up handset to your Phone and put the handset to hang up position,
then connect DC power supply to the “DC IN” port at the rear of the Phone or
insert the battery to the battery chamber. Switch the “Power” switch (on the rear
of the Phone) to ON, then press the Power On/Off Key on the panel for 3
seconds to power on the Phone, your Phone should go to idle screen and is ready
to use.
3.1.2 Power Off
You can turn the Phone off directly by switching the “Power ON/OFF”
switch (on the rear of the Phone) to OFF position. If the Phone will not be used
for long time, please turn this switch to OFF.
Or you can press the Power On/Off Key for 3 seconds to power off the
Phone.
3.2 Make a Call
While your Phone is on and at idle screen, enter a destination number you
wish to call, then press “CALL/REDIAL” Key. (Note: To modify digits you
enter, you can press “CANCEL” Key to delete wrong digits first and then enter
new digits).
Once the call is connected, the Phone’s screen will display the number you
have dialed, and the time duration the call has lasted.
The Phone also has a speaker. To use the speaker to make a call, press
“SPK” Key, enter a phone number, and press “CALL/REDIAL” Key.
3.3 Receive a Call
When there is an incoming call, the Phone will ring and display the Phone
number of the incoming call (if the number is available). You can pick up the
handset or press “SPK” Key to take the incoming call. The ring tone and ring-
tone volume can be changed in the setting menu.
3.4 End a Call
You can always end call by pressing “END” Key. If you are using the
handset for a Phone call, hanging up the handset will end the call automatically.
3.5 MUTE Key functions
When the MUTE Key is pressed at idle screen, an MUTE icon (speaker
with cross) appears on the top of LCD to indicate the phone is in silent Mode.
When there is an incoming call and phone rings, pressing the MUTE Key,
would stop the ringer sound.
During the call, if MUTE Key is pressed, your voice would NOT be heard
by far-end, and the MUTE icon appears on the top of LCD. Pressing the MUTE
Key again, would resume sending the voice to far-end.