User's Manual
FCC
statement:
Section
15.105
(b)
Note:
Thi'
equipment
has been
tested
and
found
to
complv with
the
limits
fOf
a
Cia"
Bdigrtal device,
pUfSuantto
pan
15
of
the
fCC
Rufe,.
The,e
limit,
afe
de'i~ned
to provide 'easonable prote<lion
a~ainsl
harmful interference
in
a re,idential in<laUation. Thi'
equipment generates,
use,
and can radiate radio
frequency enerp;v
and,
if
not in,talled
and
used
in
aocOfdance with
the
in,tructions, may
cau,e
harmful
interference
to
radio communications. Ho"",,ver,
the,e
i,
no guarantee
that
interference
will
not occur
in
a
panicular in'!;IlIalion.lf
this equipment
doe'
cause
harmful interference
to
radio or televi'ion feception,
which can be determined
bV
turning
the
equipment off
and
on,
the
user
i'
encouraged to try to correct
the
Interf",ence
bV
one
or
mOfe
01
the lollowing mea,ures:
--Reorient
or
'elocate
the
,eeei"inK antenna.
--Increase
the
'epa
ration
between
the
equipment and
rece'ver.
--Connect
the
equipment into an outlet
on
a
Cifcuit
different from that to which
the
,eceiver
i'
connected.
--Consult
the
dealer
Of
an eXI""ienced
radio{TV
technician for help.
FCC Section 15.21 Inrormation to the user
Changes or
modifications not
e~pressly
approved by the party responsible for compliance could void the
use~s
authority to
operate the equipment.
FCC Section 15.19
Labellif1g requirements
This device complies with Part 15
of
the FCC Rules.
Operation is s.ubject
to
the following
1wo
conditions:
1.This deYice may not
calISe harmful interference. and
2.This deYice must
acce~
any interference received,
including
Interrerence that may causeundesired operallon.
SAR
INFORMAllON
The SAR limit
of
USA (FCC) Is 1.6 WIkg averaged over one gram
of
tissue.
Device
types (FCC
10:
PH7P~130N
) has
al&o
been tested against ttlis SAR limit.
The
highest SAR value reported under this standard
dur1ng
product certlftcatlon
for
the body is I
0.57
IWlkg.
This device
was
tested for lVoical.bodv-worn oDeratlons with the back
of
ttle handset kept 0
cm
rrom ttle body.
To
maintain compliance
wItt1
FCC
RF
e~posure
requirements, use accessories that maintain a 0 cm separation
distance between Ihe
use~s
body and ttle back
ofttle
handset. The use or bell
dips,
holster& and similar accessories should not contain metallic components in
h a$sembly. The use or accessories that do not satisfy these requirements may
nol comply with FCC RF
e~posure
requirement$, and should be avoided