User's Manual

9
GSM FWP
PG130/131N
3.3.5 Display Icon
The following icon may appear on the display of the phone:
No.
Icon
Description
1
Current signal strength. The more bars there are, the stronger the signal is.
2
No signal.
3
Battery capacity indicator. The more bars there are, the more capacity the
battery has.
4
Supplied by charger
5
Alarm on
6
Call forwarding
7
Missed call
8
Unread message
9
RM
Roaming
10
Speakerphone active
Figure 3 Display Icon
4 Basic Operations
4.1 Power On/Off
Connect the handset to the underside of the phone, then open the battery door and connect the
battery. Plug in the power adapter into AC outlet, and then connect the other end of the power
adapter into the right side of the phone.
Switch the <Power> switch (on the underside of the Phone) to ON, then press the <Power On/Off>
Key on the panel for 3 seconds to power on the phone, your phone should go to standby screen and
is ready to use.
You can turn the phone off directly by switching the <Power On/Off> switch (on the rear of the phone)
to OFF position. If the phone will not be used for long time, please turn this switch to OFF. Or you can
press the <Power On/Off> Key for 3 seconds to power off the Phone.
Note: Before press the Power ON, please turn the hardware switch to ON which in the bottom side of
the phone.
4.2 Make a Call
While your phone is power on and at idle screen, enter a destination number you wish to call and then
press <Redial> Key. (Note: To modify digits you enter, you can press <CLEAR> Key to delete wrong
digits first and then enter new digits). Once the call is connected, the phone’s screen will display the
number you have dialed, and the time duration the call has lasted.
The phone also has a speaker. To use the speaker to make a call, press <SPEAKER> Key, enter a
phone number, and press <REDIAL> Key.
4.3 Answer a Call
When there is an incoming call, the phone will ring and display the Phone number of the incoming call
(if the number is available). You can pick up the handset or press <SPEAKER> Key to answer the
incoming call. The ring tone and ring-tone volume can be changed in the sounds menu.
4.4 End a Call
You can end a call by pressing <Clear> KEY to select End. If you are using the handset for a phone
call, hanging up the handset will end the call automatically.