User's Manual

Web-Based Advanced User Interface

You can easily setup the router’s advanced functions through your web browser and without

having to install additional software onto your computer. There are no drivers to install and,

you can easily make changes and perform setup functions from any computer which is

connected to your MV600

 NAT IP Address Sharing

 Support for VPN Pass Through

 Built in Dynamic Host Configuration Protocol (DHCP)

 Integrated 802.11b/g/n Wireless Access Point

 MAC Address Filtering

Integrated 10/100 4-Port Switch

The MV600 has a built-in, 4-port network switch to allow your wired computers to share printers,

data and MP3 files, digital photos, and much more. The switch features automatic detection so it

will adjust to the speed of connected devices. The switch will transfer data between computers

and the Internet simultaneously without interrupting or consuming resources.

Integrated 802.11 b/g/n Wireless Access Point

The MV600 supports Wi-Fi modes b/g and n. Your router as default is set to Wi-Fi mode g. To

use mode n you can change this by logging into the web interface (instructions are in section

3.10). Although, please ensure that your Wi-Fi card supports n mode.