User's Manual

3 Locate the power supply that is included with your router. Plug the power supply’s small

connector into the power port on the router (9). Plug the power supply into an empty

power outlet.

4 Switch on the router (8). Look at the Power LED on top of the router and make sure the

lights are ON.

5 Wait for a few seconds while the router searches for network service. When the router

finds a suitable network, the Signal LED turns blue and will flash dependent upon the

strength of the acquired signal. Refer to the Signal Strength LED description for more

details.

6 Locate the Ethernet cable that is included with your router. Plug one end of this cable into

ANY Ethernet port on your router. Plug the other end of the cable into the networking port

on your computer. Alternatively connect to the router through WiFi (see below).