User's Manual

4.1.7 Pet Immunity

The AZ100 passive infrared (PIR) motion detector can be adjusted to provide pet

immunity.

Remove the back cover of the PIR motion sensor (see figure 6) to adjust the

range/sensitivity setting. Moving the jumper to the number 3 position will adjust for

minimum sensitivity. You can also adjust the angle of the sensor slightly upwards to

further minimize pet sensitivity. The sensitivity setting can be adjusted prior to or after the

sensor has been registered.

4.1.8 Removing Sensors

To remove/delete (exclusion) any motion sensors or other accessories please follow the

instructions below. You must be in the programming mode to perform this function.

Remove motion sensor or

other accessory

Func Key10Func Key

Press the sensor button

Please note: You need to press the button of the desired sensor within 30 seconds to

remove (exclude) it correctly. If the procedure has not been accomplished properly