User's Manual

36
Please note: All functions listed in this section of the user’s guide require that you
be in the programming mode to perform them. When you are in the programming
mode the Power, Battery, Signal, and Setting/Register LEDs will all be solid green.
When in the programming mode and a sequencehas been initiated a 5 second timer
will be kept. After a key is pressed, if 5 seconds elapse before another key is
pressed all 4 Zone LEDs will blink red 3 times and the programming sequence will
need to begin anew. If 30 seconds elapse before another key is pressed, the
Axesstel Home Alert will exit the programming mode.
When programming is complete to exit the programming mode use your keypad and
enter the following or simply wait for 30 seconds to elapse. All LEDs should return to their
normal state.
Func KeyFunc Key
4.1.1 Changing the Password
To change the default password use your keypad to enter the following:
Func Key00Func Keynew passwordnew passwordFunc Key