User's Manual

50
Adding 3
rd
party vendor Z-Wave device; please refer to the instructions for the Z-Wave device
that you are installing.
• Inclusion: Add a Z-Wave enabled device
On AX140 enter the command [#password75 Func-Key]; on other Z-Wave
device [Press switch to enter inclusion mode (see manufactures instructions for
device)]
• Exclusion: Remove a Z-Wave enabled device.
On AX140 enter the command [#password70 Func-Key]; on other Z-Wave
device [Press switch to enter inclusion mode (see manufactures instructions for
device)]
• Association: After inclusion, define the relationship between devices
(primary/secondary), by specifying one as primary to control the other secondary
device.
On AX140 enter the command [#password81 Group IDFunc-Key]; on the
other Z-Wave sensor [Click the button in secondary sensor first then in the primary
sensor; this will add the primary sensor to secondary sensor association group (see
manufactures instructions for device)] If no Group ID is found, user can specify
(example “1”).