User's Manual

19
NOTE: IT IS ADVISABLE TO CHANGE YOUR PASSWORD AS SOON AS YOU CONNECT
THE UNIT
*Default password is 1234. So if you wanted to change your password to 4897, then you
would enter the following:
  
 
3.2 Adding / Removing Motion Sensors
To add motion sensors (AZ100) to the AX140 please follow the instructions below. Up to 200
Motion sensors can be added across 4 zones. In the rear housing, there is a small push
button switch which is used for adding the sensor (inclusion) and remove (exclusion) of the
sensor. The following will add the AZ100 sensors (inclusion/association) to the AX140 (see
illustration below).
You will have 30 seconds to push the add button once the “Setting/Register” Led is lit.
Func
7
9
8
4

7
9
8
4
0
0
4
3
2
1
#
