User's Manual

Figure 3 Figure 4
Figure 5
Attentions:
Before sticking the module, please clean the area where you plant to stick it.
a.
Dust or humidity may cause the module fall off.
b.
Parallel the module and the magnet exactly, and the distance should be less than 10mm. Once the two parts have a distance
above 20mm, the indicator light will shine and the module will send alarm signal to the unit base. Make door contact upward
vertically.
c.
The magnet should be pasted at the side which is near the indicator light on the module. Make sure the light faces you.
Please stick the magnet on the door and the module on the door case to prevent the module’s fall which causes by the shake of
the door.
d. When the battery is out of energy, the under-voltage lamp will light, and the battery should be changed in time. Under
normal circumstances, it is suggested to change the battery once 6 mouths.
d.
Please try to shorten the distance between the module and the unit base. It is suggested less than 30 meters.
e. Try not to make the concrete wall or electrical equipments between the unit base and the module in order to prevent the
signal being cut off.
f.
Keep the module dry.
g. If the parts are found inverted, it can be pull down and stick again.
h.
After sticking the door contact, please open the door to test the alarm light of the door contact to confirm whether it lights
or not, and to confirm whether the unit base makes local alarm sound (the precondition is to open the local-alarm function),
whether the security number receives alarm message (the precondition is to set the number correctly), whether the security
number receives alarm call (the precondition is to open the voice alarm and set the number correctly).
--------------------------------
Note: