Operating instructions

TM 11-5865-229-12
c. Program Module Assembly Removal.
Perform the following procedure to remove the program
module assembly from the RT.
The program module assembly contains components that can be damaged by electrostatic discharge
(ESD) during handling. To avoid damaging these components, handle the module by the cover only.
After removing the program module assembly, store it in a static barrier bag to prevent ESD damage.
Turn system power off. Refer to aircraft manual for instructions.
Loosen four captive screws on program module assembly cover.
Carefully slide program module assembly out of the RT.
Immediately place the program module assembly into a static barrier bag and seal it with a static
caution label.
3-39