Operating instructions

TM 11-5865-229-12
Always turn system power off before connecting RT cables. If power is left on, you could be injured
or killed by high voltage in the power cable.
Release RT handle by depressing latches and lock
it in full up position.
Connect interface cable to CONTROL connector
J2 and aircraft power cable to POWER connector
J4. (Use slip joint pliers, if necessary.)
Connect antenna cable to ANT connector J1 and
tighten connector with preset torque wrench.
If necessary, reset BIT indicators on replacement RT to indicate normal condition as shown below.
BIT indicators are reset by turning them clockwise 1/4 turn.
Perform the operational test (paragraph 3-9) to make sure the CM Set is working properly.
3-21