Operating instructions

TM 11-5865-229-12
SECTION V
MAINTENANCE PROCEDURES
SECTION CONTENTS
PAGE
INTRODUCTION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-13
CCU REMOVAL AND INSTALLATION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-13
RT REMOVAL AND INSTALLATION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-18
ANTENNA REMOVAL AND INSTALLATION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-22
PROGRAM MODULE ASSEMBLY REMOVAL AND INSTALLATION ....................................
3-37
CCU KNOB AND LAMP REMOVAL AND INSTALLATION
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-41
3-10 INTRODUCTION.
This section contains general removal and installation instructions for the CM Set LRUs. Refer to the applicable
aircraft manual listed in Appendix A for specific removal and installation instructions.
3-11 CCU REMOVAL AND INSTALLATION.
a. Tools and Materials Required.
Tool Kit, Electronic Equipment TK-101/G
Screwdriver, .032 x 11/64 x 3 in
Screwdriver, #1 common-tip
b. CCU Removal.
Perform the following procedure to remove the CCU from the aircraft crew com-
partment.
High voltage present in this equipment is sufficient to cause
off before beginning procedure.
injury. Make sure system power is
3-13