User`s manual

NOTE: THE REVERSE OSMOSIS SYSTEM SHOULD BE INSTALLED

INDOORS AND IT IS SUGGESTED THAT IT NOT BE IN DIRECT SUNLIGHT OR

EXTREME COLD.

3. Connect the 3/8” or 1/4” tube fitting to an incoming water source. The minimum

water pressure should be at least 30 psi. The system’s minimum operating pressure

is 80 PSI, but the optimum operating pressure is 100 psi.

NOTE: DO NOT OPERATE AT A PRESSURE EXCEEDING 125 PSI. The

operating pressure can be increased on the face of the booster pump by turning the

hex screw clockwise.

4. Connect the concentrate 1/4” tubing (waste) line to drain.

5. Plug the booster pump transformer into a power supply of 110 or 220 volts.

6. This system has been designed with an auto-flush restrictor. This restrictor

automatically flushes the reverse osmosis system for 30 seconds every time it starts

up and once every hour when the system is producing water.

NOTE: THE TANK PRESSURE SWITCH WILL SHUT THE SYSTEM OFF

AUTOMATICALLY, WHEN THE BLADDER TANK IS FULL.

7. The sediment filter and carbon must be serviced regularly for optimal performance.

The filters and water quality should be checked every two weeks minimum.

8. Dispose of the product water until the conductivity of the product water reaches your

desired level. Use any TDS or Conductivity meter to monitor the product water

quality. A minimum quality of 96% NaCl rejection is recommended.