Quick Start Guide

• MIDDLE (backside). Use to enter menu and conrm selected opon.
• DOWN (backside). Use to navigate down in menus and to decrease radio volume
when radio sound is on.
Alert Event
In case of an alert event the receiver will acvate the siren, the LED-light will ash and
the display will also be brightned for 1 minute. The message will be shown on the
display.
To turn o the alarm press any buon.
The LED-light will connue to ash unl turned o. If the receiver is running on USB
Adresses
With ALERT FM, messages can be sent to groups of receivers based upon their locaon
or addresses. An address is a code stored in the receiver. All receivers with a matching
address will receive a message sent to this address assuming that the receiver is
properly powered (See Powering secon above) and properly tuned to an FM staon.
Please visit the My ALERT FM secon of www.alerm.com for the public address codes
available in your area. A maximum of 30 addresses can be stored.
Show Addresses: Enter menu and navigate to “Addresses”, press MIDDLE buon.
Enter new Address: Navigate to “Add new” and press
MIDDLE buon. To input the address, use the UP/DOWN
buons to scroll to desired alphanumeric digit (0-9, A-F)
and then move to next digit with the MIDDLE buon
(FRONT buon will go back to previous digit).
Note: Only enter Addresses approved by ALERT FM.
Remove an address: Navigate to the address to be
removed using the UP and DOWN buons. Press MIDDLE
buon. A conrm message is displayed. Press UP buon to
conrm removal or any other buon to abort removal.
Note that there are factory congured addresses that
cannot be removed. They are indicated with a padlock next
to them when selected.
4
In the Messages menu previously received messages are
shown. Up to 20 messages are stored in the receiver. The
number of messages stored, as well as te current message
number, are indicated at the top right corner. If the
message is longer than 3 rows the arrow to the boom
right on the display is black and indicates possibility to
scroll. Use the UP/DOWN buons to scroll. Press the
MIDDLE buon to view the next message.
Messages
Push Buons
The ALERT FM receiver is operated by four push buons.
• FRONT. Use this buon to go “back” in menus and to toggle radio sound on/o.
• UP (backside). Use to navigate up in menus and to increase radio volume when
radio sound is on.
Services
All messages sent on the ALERT FM channel are part of some service. A service has
messages of similar type, such as: alert service, weather service or a paging service.
As new services are introduced, their ID (a number) can be found on the My ALERT FM
secon of www.alerm.com. To get access to its messages, the service ID must be
entered into the receiver.
Services can be shown, added and removed in a similar way as Addresses, see previous
secon, by navigang the menu to “Services” and pressing MIDDLE buon. A maximum
of 30 Services can be stored on the device.
Note that there are factory congured services that cannot be removed. They are
indicated with a padlock next to them when selected.
power the backlight display will also be turned on unl the alarm is acknowledged.
Sengs
Note that the ALERT FM receiver will receive the important alert messages without
the need for any user sengs as long as it is locked to an ALERT FM channel (indicated
by the key symbol).
3