User's Manual

Axentia Technologies 1-B iBus EPM-1000 wireless push button User Manual v2.0.docx
Page 2 (4)
2. This device must accept any interference, including interference that may cause undesired operation
of the device.
Changes or modifications to this device, not expressly approved by Axentia Technologies AB could
void the user’s authority to operate the equipment.
FCC RF Exposure Requirements: This product complies with the FCC RF exposure limit set forth for
an uncontrolled environment and is safe for intended operation as described in this manual. This
device is only authorized for use in a mobile application, at least 20 cm of separation distance between
the radiating antenna and the user's body must be maintained at all times. Further RF exposure
reduction can be achieved if the product can be kept as far as possible from the user’s body or set the
device to a lower output power if such a function is available. Separate approval is required for all
other operating configurations, including portable configurations with respect to 47 CFR Part 2.1093
and different antenna configurations.
2.2 Industry Canada Notifications
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage ;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d’en compromettre le fonctionnement.
ISED RF Exposure Requirements: This product complies with the FCC RF exposure limit set forth
for an uncontrolled environment and is safe for intended operation as described in this manual. This
device is only authorized for use in a mobile application, at least 20 cm of separation distance
between the radiating antenna and the user's body must be maintained at all times. Further RF
exposure reduction can be achieved if the product can be kept as far as possible from the user’s
body or set the device to a lower output power if such a function is available. Separate approval is
required for all other operating configurations, including portable configurations with respect to 47
CFR Part 2.1093 and different antenna configurations
2.3 Information about FCC ID and IC ID
FCC ID: 2AR8J-EPM1000
IC: 24627-EPM1000