Manualshelf

User's Manual

ManualsBrandsAXENT ManualsHousehold ApplianceAXENT.ONE C PLUS Intelligent Toilet
31323334353637383940
29
MAINTENANCE
CLEANING INSTRUCTIONS SEAT, LID AND BACK COVER
Use a mild soap solution to clean the seat. Please take care that the seat and hinges are not left damp. Dry o any residual water or cleaning
agent with a soft cloth. Ensure that the seat and seat hinges do not come in contact with abrasive, corrosive, or chlorine-based cleaners, as these
may cause damage or lead to flash rust. When cleaning the bowl, make sure that the seat and cover are kept in an upright position until all clean-
ing agent has been flushed away.
DISCONNECT THE POWER BEFORE CLEANING THE PRODUCT.
Do NOT use any scouring equipment or tools (ex: scouring pad) or any aggressive cleaning agents for cleaning.
CLEANING CERAMIC APPLIANCES
Do not use harsh or abrasive cleaning substances such as abrasive cleansers, scouring powder or drain cleaner on your ceramic surfaces. Also
avoid using steam cleaners and hard, abrasive sponges. Please do not pour or dispose of hair coloring products into the toilet as this can reduce
the eectiveness of the AXENT Easy Clean coating.
By following these maintenance guidelines, AXENT Easy Clean should remain eective for many years. AXENT highly recommends the use of
acidic cleaners with a pH value between 1 and 4. Cleaners with a pH value in the neutral range (5 to 8) are not always suitable. We strongly advise
against using either weak or strong alkaline cleaners, i.e. substances with pH values from 9 to 12.
SUITABLE CLEANING DETERGENTS
- Mild bathroom or all-purpose cleaner
- Mild detergents
- Normal toilet brushes
- Soft sponges
- Microfiber cloth
REMOVING THE TOILET SEAT AND LID
The toilet seat and lid can be removed, cleaned and remounted quickly and easily when heavily soiled.
1. Disconnect electrical power.
2. Lift up on the toilet seat and lid.
3. Remove the toilet seat and lid by lifting up vertically so the pins come out of the mounting holes.
4. Clean the toilet seat and lid.
5. Insert the toilet seat and lid vertically from the top down into the mounting holes. Make sure the pins are aligned properly.
6. Let the toilet seat and lid glide down.
7. Connect the electrical power.