User's Manual

17
OPERATION WITH MAIN
LEVEL  > AUTO DRY SETTING
Factory setting: OFF
2
LEVEL 2 is activated,
Press and hold the Multifunction dial.
Turn it counter clockwise.

- ON One time short «beep»

- OFF Two times short «beep»
When the Auto Dry setting is ON, the Dry function will be started after pressing the Multifunction dial to
stop Rear or Front wash.
LEVEL  > SYSTEM RESET
2
LEVEL 2 is activated,
Pull the Multifunction dial.
Turn it counter clockwise to start System Reset.

- All settings are reset to factory defaults. This will be followed by a short
«beep».
STANDBY MODE
Press and hold the Multifunction dial until ambient light off to activate
the Stand-by mode.

- Slap the toilet rear cover to deactivate Stand-by mode.
In Stand-by mode, the intelligent toilet will remain powered, but electronic functions will be disabled.
PAIRING TO DIAL
Cut o the power of the intelligent toilet and wait for 30 seconds and then
apply power to it.
After three times short «beep», the pairing is started by pressing Multi-
function dial repeatedly within 20 seconds until hearing three times long
«beep» from the intelligent toilet, which means pairing successful.
Pairing has originally been done in the factory. It is necessary only after you replaced your dial.