User's Manual

MBF-40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
www.cobham.com/wireless Date: 14-Feb-16 Cobham Wireless – Coverage
Page | VIII
Rev. 4.3 Document number: 00071UM
Warning: Restricted
Access Location
Access to the MBF-40 unit installation location is restricted to authorized
SERVICE PERSONNEL.
Attention: Electrostatic
Sensitivity
• Observe electrostatic precautionary procedures.
• ESD = Electrostatic Discharge Sensitive Device.
• Static electricity can be conducted to the semiconductor chip from the
centre pin of the RF input connector, and through the AC connector pins.
When unpacking and otherwise handling the repeater, follow ESD
precautionary procedures including use of grounded wrist straps, grounded
workbench surfaces, and grounded floor mats.
Caution: Class 1 Laser
The repeaters described in this manual are equipped with class 1 lasers, as
per definition in EN 60825-1
Caution - Un-terminated optical receptacles may emit laser radiation. Exercise
caution as follows:
• Do not stare into beam or view with optical instruments. Optical
transmitters in the Fibre optic converter can send out high energy invisible
laser radiation. There is a risk for permanent damage to the eye.
• Always use protective cover on all cables and connectors which are not
connected.
• Never look directly into a Fibre cable or a connector.
• Consider that a Fibre can carry transmission in both directions.
• During handling of laser cables or connections, ensure that the source is
switched off.
• Regard all open connectors with respect and direct them in a safe direction
and never towards a reflecting surface. Reflected laser radiation should be
regarded as equally hazardous as direct radiation.