User's Manual

MBF-40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 14-Feb-16 www.cobham.com/wireless
Document number: 00071UM Rev. 4.3
Page | 2-21
5. Connect the Fibre(s) to the Fibre Optic Converter inside the repeater.
• For MIMO MBF-40, connect two fibres to the two optic converters installed in the
repeater. See Figure
2-21: MIMO Dual F/O Connection.
• Make sure the Fibre is not bent too sharply inside the repeater as to avoid
communication disruptions.
Figure 2-20: Single F/O Connection
Figure 2-21: MIMO Dual F/O Connection
6. Place the Fibre(s) in the rubber seal (for
MIMO, run both Fibres in the same rubber
seal).
NOTE: The sleeve (not supplied), together
with the rubber seal, meets the protection
standard IP65/NEMA4.
Figure 2-22: Run Fibre in the Rubber Seal
7. Adjust the Fibre(s) length inside the repeater
and insert the seal into the Fibre inlet.
Figure 2-23: Adjust F/O Length
Single F/O Connector
Dual F/O Connectors