User's Manual

MBF-40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 14-Feb-16 www.cobham.com/wireless
Document number: 00071UM Rev. 4.3
Page | 1-7
1.7.2 External Interfaces
The repeater’s interfaces are located on the underside. Two basic models are available: single and
dual service antennas.
NOTE: The external connections at the bottom of the repeater can be protected with a cover which is
screwed in place.
Figure 1-7: Single Service Antenna Figure 1-8: Dual/MIMO Service Antenna
The following table provides a description of the front panel ports and connections.
Port Description
Server Service antenna connection - DIN 7/16” connector, female
Optic SC/APC Fibre optic inlet through which the optic Fibre is routed for internal
connections (section
2.2.6).
For MIMO models – route the two Fibres via the Fibre port.
NOTE: Optic Fibre Conduit hose fitter may be pre-assembled.
Power
Plinth connection for routing power for internal connection (section
2.2.8.1)
Alarms Plinth connector for routing external alarms and relay wiring cable for internal
connections (section
2.2.9).
GND
Grounding lug (section
2.2.4)
Fibre Input
Power Alarms
Server antenna
Fibre Input
Power Alarms
Server antennas