User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 Repeater Installation
- 3.1 Location Criteria
- 3.2 Standard Repeater Installation
- 3.3 Repeater with Fan Hood Installation
- 3.4 Five-Band System Installation
- 3.5 Grounding
- 3.6 Ensure Good EMV Protection
- 3.7 Fiber Optic Connection
- 3.8 External Alarm and Relay Connections
- 3.9 Power and Backup Battery
- 3.10 Power ON
- 3.11 Closing and Securing the Repeater
- 4 Opening a Session and Navigating GUI
- 5 MBF-40 Commissioning
- 6 MBF-40 Full GUI Description
- 7 Monitoring and Fault Sourcing
- 8 Maintenance
- Appendix A - US Specifications
- Appendix B - Canada Specifications
- Appendix C – F/O Cleaning Procedure
AXELL MBF-40 AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd Doc. No. 00071UM Rev. 3.4 77
7.3 Module LEDs
This section describes the LEDs of the internal modules. The modules are accessed if the
remote is opened. An example of the MBF-40 Dual-band, dual-service antenna model is
given below:
Figure 7-7: Dual band Dual Service Antenna Model
NOTE: MIMO models include two optic converter modules with separate LED indicators. Both
modules’ LED status should be checked.
F/O converter module
LEDs, see 7.4.2
Controller module
LEDs, see 7.4.1
Power module LEDs,
see 7.4.3