User's Manual

AXELL MBF-40 AMERICAS REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
© Axell Wireless Ltd Doc. No. 00071UM Rev. 3.4 57
The OLA screen appears. The screen lists the OLA options (and status) for each link.
(The links are listed according to the OMU II slot to which the remote is connected.).
Figure 5-2. Configure and Initiate Optical Loss Adjustment
Column Description
Pos
Each Rack corresponds to an OMU unit whereas each Slot
corresponds to an Opto-
Module. Slots are numbered
according to their position in the OMU Chassis (numbered left
to right).
Select All Batch selection options:
- mark all remotes for UL opto-adjustment.
- mark all remotes for DL opto-adjustment.
- mark all remotes for DL and UL adjustment.
Node Node list number and identification (e.g. AHFK)
Status
Displays an Error if process failed. If successful the pilot tone
used and the adjustment level will be displayed.
Resulting
Attenuation
Compensation level used for the opto-module (in dB).
3. Mark the check-boxes corresponding to the remotes (each connected to the
designated Opto-module/Opto-Splitter) to which to perform the adjustment.
4. OLA (DL/UL) may be performed on each node individually (or a batch) or on all
nodes at once by marking the checkbox next to the desired corresponding Opto-
module and clicking Adjust.
To easily mark all checkboxes mark the checkbox named OLA.
NOTE: The process may take several minutes depending on the size of the system and remote
distance.
Rack#:Opto-
Module
Select nodes
for UL/DL
Adjustment
F-DAS
Remotes via
Optic Splitter