User's Manual

AXELL MBF -40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
46 Doc. No. 00071UM Rev. 3.4 © Axell Wireless Ltd
3.10 Power ON
3.10.1 Switching Power ON
CAUTION!! Make sure the antenna cables or 50 ohm terminations are connected to
the repeater’s antenna connectors before the repeater is turned on.
To switch power on
1. Switch on the Main Power Switch.
2. Switch on the Secondary Power Supply (model dependent).
3. Switch on the Battery power.
Note: Both power supplies must be switched ON to power up the unit.
Figure 3-37: MBF-40 Power Module
NOTE: The power switches have two positions: “on” and “stand by”. In the stand by position the
repeater is still connected to the power supply but not operational.
3.10.2 Verifying LEDs
Verify the LEDs from the following modules are indicating correct operation (see section
7.3):
• Control module
• F/O converter(s)
• Power supply module(s)
3.11 Closing and Securing the Repeater
Close lid, tighten the screws and lock repeater. Continue with the following section to
setup the repeater.
NOTE: The two screws must be fully tightened. Failure to do so may affect the IP65 compliancy and
therefore any warranty.
Main Power
Switch
Battery
Switch
Secondary
Power Supply
Main Power
Supply