User's Manual
Table Of Contents
- 1 Introduction
- 2 Installation Requirements
- 3 Repeater Installation
- 3.1 Location Criteria
- 3.2 Standard Repeater Installation
- 3.3 Repeater with Fan Hood Installation
- 3.4 Five-Band System Installation
- 3.5 Grounding
- 3.6 Ensure Good EMV Protection
- 3.7 Fiber Optic Connection
- 3.8 External Alarm and Relay Connections
- 3.9 Power and Backup Battery
- 3.10 Power ON
- 3.11 Closing and Securing the Repeater
- 4 Opening a Session and Navigating GUI
- 5 MBF-40 Commissioning
- 6 MBF-40 Full GUI Description
- 7 Monitoring and Fault Sourcing
- 8 Maintenance
- Appendix A - US Specifications
- Appendix B - Canada Specifications
- Appendix C – F/O Cleaning Procedure
AXELL MBF -40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
30 Doc. No. 00071UM Rev. 3.4 © Axell Wireless Ltd
6. Fan Hood power connections:
Connect the Front Fan Hood and the Rear Fan Hood power connectors to the
Repeater power connectors.
Figure 19: Slide Front Fan Hood onto MBF
3.4 Five-Band System Installation
NOTE: Both Master MBF-40 and Slave MBF-40 (5-band system) unit models differ from the
standard MBF-40 single-clamshell and dual-clamshell models. The installation of the latter models is
described in section 3.2
This section describes the installation procedure for a five-band system. The 5-band
system consists of two units: Master MBF-40 and Slave MBF-40. All the services are
routed to the Master unit via the optic fiber, where the Master and Slave are managed
as a single unit via the Master connections.
Connect power of Rear and
Front Fan Hood assemblies